Diesel cutting machine installation and commissioning

First, the lifting
       Packaging machine into two parts, the host at the bolted-down box, rectum weapon, long axis wrap with plastic film after nailing, cable tray and other parts are made of wood and nails fixed in the box on the floor .
       When lifting Diesel cutting machine is equipped with boxes, crates should be lifting the rope lines mark set in place during handling and discharge must do the bottom, side and intense vibration impact, in any case, inclination to excessive packaging.

Second, the installation
       Host and reels are placed when mounted horizontally, to ensure smooth placement without phenomenon agitation must be adjusted after the long axis and linear weapon mounted horizontally, Diesel cutting machine so that the gun directly to the line with the axis of the host trough the hole in the same line.

Third, debugging
       Before the implementation of each moving parts cleaning, then the holes in the guide sleeve, the groove of the front wheel with oil lubrication, the rest of the press lubrication lubrication requirements. When  Diesel cutting machine, the first test idle test. During the test, the engine, the positive and negative controls check each part is working properly, without abnormal noise. Before starting work you can start after determining reliable bank transfer, by commissioning of the entire plate and cut to length plate, respectively, to ensure the fairness and length to meet the requirements