Diesel cutting machine rules

1. Shuttle countertop material should maintain the level and lower cutter, table length can be determined according to the length of the workpiece.

2. Before you start, you should check to make sure no cracks cutter, turret bolt, solid shield. Then rotate the pulley by hand to check the gear meshing clearance, adjust the cutter gap.

3. After starting, you should first dry run, check after each transmission parts and bearings in normal operation only after the job.

4.Cyq50a Diesel Powered Cutting Machine does not reach normal operating speed may not cut material. When cutting, use the cutter, the lower parts of the alignment edge grip reinforced quickly put, the operator should stand on the side of force to suppress the fixed blade steel, should be reinforced to prevent the end of the pop-up hurt. It is prohibited on both sides of the blade with both hands holding the steel sub-leaning feeding.

5. Can not cut diameter and strength than steel and red-hot steel mechanical nameplate. Once cut off when a plurality of reinforcement, the total cross-sectional area should be within the specified range.

6. When Cyq50a Diesel Powered Cutting Machine, replace the high hardness cutter, cutting machine plate diameter should be consistent with the provisions.

7. When cutting short material, distance between the hand and the knife should be maintained at 150mm or more, such as when hand side is less than 400mm, should be reinforced short sleeve or jig head pinched or folder in prison.

8. Operation, prohibited by hand directly decapitation and remove debris near the cutter. Rebar cutter swing around and around, can not stay non-operators.

9. When they find machinery not functioning properly, abnormal noise or skew cutter, you should immediately downtime.

10. After the operation, steel brush to remove debris between the cutter, carry out the whole cleaning lubrication.

11. Hydraulic fluid front cutter Diesel cutting machinejob, check that the hydraulic oil and motor rotation direction to meet the requirements. After starting, it should load operation, loose open valve, drain the body of the air cylinder net, only for cutting.

12. Manual hydraulic cutting machine before use, oil drain valve should be tightened clockwise, after cutting is completed, immediately unscrew counterclockwise. Jobs, steady hand should be cut off the machine, and wear insulated gloves.